USING THE FILL POLYGON COMMAND


     The Fill Polygon ( FP ) command, fills the polygon
     currently in the polygon buffer.  For more information
     see the PCL 5 Printer Language Technical Reference
     Manual.

     LEGEND: Ec = [Ctrl] [P] [Esc] in DOS EDIT.


     EcE                           Resets the printer.

     Ec%0B                         Enters HP-GL/2 mode.

     IN;                           Initializes HP-GL/2 mode.

     SP1;                          Selects pen number 1,
                                   (black). Even though
                                   there is no physical pen,
                                   the SP command must be
                                   used to enable printing.

     PA1500,1500;                  Specifies absolute
                                   plotting, then moves to
                                   (1500,1500).

     PM0;CI1000,60;PA1500,1500;CI500;PM2;    Enters the
                                   polygon mode, stores a
                                   circle with radius of
                                   1000 plotter units (plu)
                                   and a 60 degree chord
                                   angle. Stores a pen move
                                   to (1500,1500), and
                                   another circle with a 500
                                   plu radius and a 5 degree
                                   (default) chord angle.
                                   Closes the current
                                   polygon and exits the
                                   polygon mode.

     LT4;FT3,50,45;                Selects line type 4 and
                                   fill type 3. Specifies a
                                   50 plu distance between
                                   the fill lines, and
                                   slants the lines at a 45
                                   degree angle.

     FP;                           Using the even-odd fill
                                   method, this fills the
                                   polygon currently in the
                                   polygon buffer with the
                                   line and fill types
                                   specified in the command
                                   above.

     Ec%0A                         Enters the PCL mode.

     EcE                           Sends a reset to end the
                                   job and eject the page.

            Copyright  Hewlett-Packard Co. 1993
   The information contained herein is subject to change
                      without notice.
   Hewlett-Packard shall not be liable for incidental or
  consequential damages in connection with the use of this
                         material.