DRAWING CIRCLES


     The CI command uses your current pen position as the
     center of the circle; you specify the radius of the
     circle.  For more information see the PCL 5 Printer
     Language Technical Reference Manual.

     LEGEND: Ec = [Ctrl] [P] Esc] in DOS EDIT


     EcE                           Resets the printer.

     Ec%0B                         Enters HP-GL/2 mode.

     IN;                           Initializes HP-GL/2.

     SP1;                          Selects pen number 1,
                                   (black). The SP command
                                   must be used to enable
                                   printing.

     PA2400,2500;                  Specifies absolute
                                   plotting and moves to
                                   position (2400,2500).

     CI500;                        Draws a circle with a
                                   radius of 500 plu
                                   (plotter units); the
                                   center of the circle is
                                   the current pen location
                                   (2400,2500).

     Ec%0A                         Enters the PCL mode.

     EcE                           Sends a reset to end the
                                   job and eject the page.


            Copyright  Hewlett-Packard Co. 1993
   The information contained herein is subject to change
                      without notice.
   Hewlett-Packard shall not be liable for incidental or
  consequential damages in connection with the use of this
                         material.