JOB CONTROL COMMANDS DUPLEX / SIMPLEX


DEFINITION
     This Command (Ec  designates either simplex or
     duplex printing for duplex printers.  The l is
     equivalent to a lower case L.  Simplex mode prints an
     image on only one side of the page.  Duplex mode prints
     images on both sides of a page.

          # = 0 Simplex (The number zero)
          # = 1 Duplex, Long Edge Binding (11"edge of paper)
          # = 2 Duplex,Short-Edge Binding (8 1/2" edge of
                paper)

EXAMPLE
     The following is an example of switching from duplex to
     simplex within the same job.

     EcE                           Printer Reset

     Ec                         Number of copies = 1

     Ec                         Duplex Long Edge Binding

     Page 1 side 1                 Text

     Ec                         Page Side Selection (Next
                                   Side)

     Page 1 side 2                 Text

     Ec                         Eject Page

     Ec                         Simplex Printing

     This is a page 2 simplex      Text

     Ec                         Duplex Long Edge Binding

     Page 3 side 1                 Text

     Ec                         Page Side Selection (Next
                                   Side)

     Page 3 side 2                 Text

     EcE                           Printer Reset (Eject
                                   Page)


     LEGEND: Ec = [Ctrl] [P] [Esc] in DOS EDIT




            Copyright  Hewlett-Packard Co. 1993
   The information contained herein is subject to change
                      without notice.
   Hewlett-Packard shall not be liable for incidental or
  consequential damages in connection with the use of this
                         material.